-
STP(Spanning-tree Protocol): Layer 2 protocol used in LAN enviroment to avoid: Broadcast Storms Mac-Table Inestability... -
Redistributing into OSPF Example syntax: R1(config)#router ospf 1 R1(config-router)#redistribute connected % Only classful networks will... -
The passive - interface command is used in all routing protocols to disable sending updates out from a specific interface. However the comm... -
R3 configuration and output R3#sh run int serial 1/0 Building configuration... Current configuration : 264 bytes ! interface ... -
Frame relay interfaces can be configured as Physical, Multipoint and point-to-point interfaces. Frame relay routing protocols and mostly al...
-
EIGRP is the most complex metric between all routing protocols metrics, in this post we are trying to clear the calculation of this metric ... -
Summarization in RIP and EIGRP can be configured manually using the IP summary-address command or automatically using auto-summary command.... -
Area authentication To enable authentication for an OSPF area, use the area authentication command in router configuration mode. To rem... -
The default behavior of redistribution of VRF aware OSPF will lead to the MPLS VPN cloud trying to emulate OSPF. This is done using a “Supe... -
Policy-based routing, generally referred to as “policy routing”, is the use of route maps to determine the path a packet will take to get t...
0 comments:
Post a Comment